Flying Pig and Swing Ride Lab

Flying Pig and Swing Ride Lab

In Part 1 you will make measurements on a real conical pendulum, the flying pig, and use them to predict its period. In Part 2 you will collect data from a swing ride simulation, choose the axes for a straight-line graph, and use its slope to measure g.

Show your work for every question, and record your swing ride data in the table in Part 2. Use g = 9.8 m/s² unless a question says otherwise.

Part 1 · The flying pig

A toy pig hangs from the ceiling on a string of length L. When its wings flap, it flies in a horizontal circle of radius r, a distance h below the point where the string is attached, with the string at an angle θ from the vertical.

θ L h r
Side view
r string attached above this point direction of travel
Overhead view

Procedure

  1. Measure the length of the string, L, from the attachment point to the center of the pig.
  2. Turn the pig on and give it a gentle push so it flies in a steady horizontal circle.
  3. Measure the vertical distance h from the attachment point down to the pig while it is flying.
  4. Time 10 complete revolutions with a stopwatch.

Questions

Part 2 · The swing ride

In this swing ride, every chain hangs from a single pivot under the ride’s overhead frame, so each seat is a conical pendulum exactly like the flying pig. A seat on a chain of length L swings out to an angle θ and hangs a vertical distance h = L cos θ below the pivot. You will use a straight-line graph to measure g.

θ L h r
One seat seen from the side: h = L cos θ and r = L sin θ

Background

h = (g / 4π²) · T²

Simulation: swing ride

Stopped
Side view
Protractor: θ is measured from the vertical dashed line
5.5 s
8.0 m
80 kg
The sliders lock while the ride is running. Read θ to the nearest degree; the chains sway slightly, so freeze the ride before you read the protractor.

Procedure

  1. Set the chain length to 8.0 m and the period to 5.5 s. Press Start ride and wait until the status says Steady.
  2. Press Freeze and read the chain angle θ on the protractor to the nearest degree. Record T and θ.
  3. Press Stop ride, change the period, and press Start ride again. Keep L = 8.0 m and collect at least 7 data points with periods between 3.0 s and 5.5 s. Include a data point at exactly 4.0 s; you will need it in 2h.
  4. For each data point, calculate h = L cos θ and the quantity you chose for your horizontal axis in 2b.

Data table (L = 8.0 m)

TrialPeriod T (s)Angle θ (°)Height below pivot h (m)
1
2
3
4
5
6
7
8
Label the last column with the horizontal-axis quantity you chose in 2b. Your entries are saved in this browser only.

Analysis